Firestate88
Member
Registered: 10th Jul 08
Location: Northampton England
User status: Offline
|
is it possible to roll corsa b arches? and do they look any gd?
also where can washer jets be relocated to? in the scuttle panel?
 
|
James_H
Member
Registered: 16th Sep 07
Location: Slough, Berkshire
User status: Offline
|
I put the washers in the front wiper arms, using matiz rear wiper nossles, you can put them in the scuttle aswell.
|
alan-g-w
Member
Registered: 9th Nov 07
Location: Glasgow
User status: Offline
|
What do you mean by 'do rolled arches ona corsa b look any good?'
I was always under the impression that rolled arches meant that you trimmed a bit off the inside to allow room for wheels - thus not making any difference to the looks of the outside?
|
Firestate88
Member
Registered: 10th Jul 08
Location: Northampton England
User status: Offline
|
nah by rolled arches i mean making them wider and higher then standard arches
|
mattk
Member
Registered: 27th Feb 06
Location: St. Helens
User status: Offline
|
guide in the FAQ section for flaring arches, basically twat them with a block of wood and a hammer
|
alan-g-w
Member
Registered: 9th Nov 07
Location: Glasgow
User status: Offline
|
quote:
Originally posted by Firestate88
nah by rolled arches i mean making them wider and higher then standard arches
So you want a wide arch bodykit? That's something totally different to rolled arches.
Put 'wide arch corsa b' into google and a couple will come up I'm sure
|
Firestate88
Member
Registered: 10th Jul 08
Location: Northampton England
User status: Offline
|
nah i dont want wide arch body kit
looking at making the standard arches just a little bit wider thats all
|
alan-g-w
Member
Registered: 9th Nov 07
Location: Glasgow
User status: Offline
|
quote:
Originally posted by mattk
guide in the FAQ section for flaring arches, basically twat them with a block of wood and a hammer
What do you mean by flaring? Surely if you did that it would just crack the paint and look as if it was dented from the inside?
|
Minty_Fresh
Member
Registered: 1st May 08
Location: westmidlands
User status: Offline
|
just get a proper arch rolling tool..
cant realy roll corsa arches as they have the plastic covers, but can trim them and bond the arches on to make room for alloys when lowering quite abit..
but wont exactly make them look any wider, may need to ask a place to make some wider plastic arches up...
|
