pedros
Member
Registered: 14th Apr 08
User status: Offline
|
keep reading forums and its not happening for me. I get power but cant link to the ecu . So annoying as i bet its something really silly im doing. Anyway here are some pictures to ask you which wire does it connect to the ECU. I've read all over here and seen its a green wire but exactly which one... Thanks for your help.
Wires everywhere
Is the wire i connect in this block, the square one??
I have wired to the Blue wire 2nd bottom from the left, but this did not work. As you can see there are also green wires that i have read people have wired too. There was four in this set and also found that there was another green wire but covered over in a thick black "overcoat" Is it in this set of wires? if so which one?
|
James_H
Member
Registered: 16th Sep 07
Location: Slough, Berkshire
User status: Offline
|
for the rev counter?
Its the small block connecter, the green one.
|
scotts v6
Member
Registered: 3rd Aug 07
Location: leeds west yorkshire
User status: Offline
|
yep what he says ^^^^^^^ small block only green wire init lol and think its pin 3 at the top behind clocks
|
Kyle471
Member
Registered: 22nd Feb 08
Location: Wombwell, Barnsley
User status: Offline
|
ok i had same prob.. located green wire and ran a wire from there to my clocks but need a connector for the clocks.. u know where all the matal things are
|
scotts v6
Member
Registered: 3rd Aug 07
Location: leeds west yorkshire
User status: Offline
|
u dont lol just fold the wire a few times and push it in
|
Kyle471
Member
Registered: 22nd Feb 08
Location: Wombwell, Barnsley
User status: Offline
|
sweet ima do it in morning
|
scotts v6
Member
Registered: 3rd Aug 07
Location: leeds west yorkshire
User status: Offline
|
a used a specker termanal and its been fine
|
Kyle471
Member
Registered: 22nd Feb 08
Location: Wombwell, Barnsley
User status: Offline
|
a what?
|
James_H
Member
Registered: 16th Sep 07
Location: Slough, Berkshire
User status: Offline
|
Or solder it
|
Kyle471
Member
Registered: 22nd Feb 08
Location: Wombwell, Barnsley
User status: Offline
|
solder the wire end n just leave it sitting behind the clocks?? will it not slip out?
|
scotts v6
Member
Registered: 3rd Aug 07
Location: leeds west yorkshire
User status: Offline
|
just fold the wire afew times so it fits tightish job dun
|
pedros
Member
Registered: 14th Apr 08
User status: Offline
|
When you all say its the block connector is it the 2nd picture i showed you?
Thanks for your helps.
quote:
located green wire and ran a wire from there to my clocks but need a connector for the clocks.. u know where all the matal things are
Its an external revcounter so do i still need to run to the clocks?
|
scotts v6
Member
Registered: 3rd Aug 07
Location: leeds west yorkshire
User status: Offline
|
no mate run it to the rev counter
|
pow
Premium Member
Registered: 11th Sep 06
Location: Hazlemere, Buckinghamshire
User status: Offline
|
Just go to scrappers and nick one pin out of a corsa. Do it properly.
|
pedros
Member
Registered: 14th Apr 08
User status: Offline
|
okidoke, so its that green wire in the square block in the 2nd picture?
|