george
Member
Registered: 23rd Feb 08
Location: Rainham, Kent
User status: Offline
|
putting xe into my corsa, just want to know if i get motorsport hubs can i just use standard 2 litre shafts? and can i use my standard gear linkage with gearbox spacer? also would anyone have any kind of wireing diagram for the ecu to dash wireing?
thanks, george
|
smokey corsa
Member
Registered: 29th Sep 08
Location: leicester
User status: Offline
|
nope, use corsa gsi/diesel shafts, mk2 cav 1600cc inner cv's with the standard outer hubs/cv's. you will need to modify your linkage but depends on how much you have to space gear box. as for wiring ill have a look.
|
boz_gsi
Member
Registered: 12th Apr 07
Location: stoke-on-trent
User status: Offline
|
as he sed abouve, and as for wiring its colour to colour,
|
smokey corsa
Member
Registered: 29th Sep 08
Location: leicester
User status: Offline
|
Before you fit the engine you need to remove the starting and charging loom from the original corsa engine and fit it to the xe. This makes the wiring really easy as now you have two completely separate discrete looms. Once the engine is in the car you simply plug the original corsa starting and charging loom back into the corsa car loom.
When you removed the corsa engine loom (with the engine) you should have been left with a square 9 pin plug in the drivers side foot well. The complete xe loom remains on the engine throughout and simply feed through the bulkhead in the same place as the original corsa loom. On the end of the xe loom you have 3 plugs which will need to be cut off, some of these will be joined to the 9-pin plug and some simply left. (you can cut the plug off the corsa loom and use this on the end of the xe loom so that you can still easily unplug it for removal. (Easier to do this before you fit it to the car)
Wiring colours are as follows:
XE loom
Green - revcounter feed, wire to green on corsa plug (some corsas may not have this wire, in which case use a bullet connector and run a green wire to the rear of the clocks if you wish to fit a set with a revcounter.
Brown/Blue - ECU light, match to corsa plug
Brown/White - Diagnostics, match to corsa plug
Brown/Yellow - Diagnostics, match to corsa plug
Blue/red (thick) - Fuel pump feed, match to corsa plug
Blue - Coolant temp sensor feed for dash clocks, match to plug
Red/White - Autobox, unused in conversion
Red/Blue (thin) - electronic speedo feed, match to corsa plug
Red (large) - Battery +ve
Black (thin) - Battery -ve you can move this inside and matched it to the corsa plug
Black/green - Aircon, unused in conversion
You can move the permanent live feed to inside the car at the 9 pin plug instead of to the battery, the A/B fuelling plug is in there as well etc, but this isn?t necessary.
Fuel relay block remains as is.
|
george
Member
Registered: 23rd Feb 08
Location: Rainham, Kent
User status: Offline
|
thanks for the help smokey will definatly come in handy
|