dangsi
Member
Registered: 9th Oct 08
Location: Berkshire Drives: lexus gs300/ vauxhall corsa b
User status: Offline
|
any one no how to take the door lock off the backin plate as been at it half hour now with no luck
ive looked in the tutorals but just says remove clip any ideas where the clip is as ive looked and few other people have but no luck
any help be great
|
adz_gsi
Member
Registered: 20th Sep 08
User status: Offline
|
- Remove the door inner trim panel
- With the window fully raised undo the retaining bolt(s) from the base of the window guide, and manoeurve the guide out of the door.
- Release the retaining clips by pivoting them away from the rods, and free the link rods from the lock assembly.
- Unscrew the two handle retaining nuts, and detatch the lock cylinder mounting plate from the rear of the handle
- Lift the retaining clips on the base of the handle, and remove the handle from the outside of the door.
Remove the exterior door handle as described above, then manoeuvre the lock cylinder mounting plate out of the door.
Where necessary, trace the wiring back from the central locking/alarm microswitch, and disconnect it at the wiring connector to enable the plate to be removed.
With the mounting plate removed, insert the key into the lock cylinder, then prise off the C clip from the rear of the mounting plate. Lift off the link rod bracket and spring, noting their correct fitted locations, and withdraw the lock cylinder
|
adz_gsi
Member
Registered: 20th Sep 08
User status: Offline
|
try this m8 from another source
|
dangsi
Member
Registered: 9th Oct 08
Location: Berkshire Drives: lexus gs300/ vauxhall corsa b
User status: Offline
|
sorted now thanks m8
|
adz_gsi
Member
Registered: 20th Sep 08
User status: Offline
|
no worries pal
|
dangsi
Member
Registered: 9th Oct 08
Location: Berkshire Drives: lexus gs300/ vauxhall corsa b
User status: Offline
|
rite slight problem adz m8
i have put the new delock handles on evey think pluged back in but still have the rod that goes from c locking bit to the key lock but as i dont have a key lock where does the rod attach to or do i not need it ?
i no were the metal rod goes i no one end goes to c lockin bit
but other use to go to they door lock but not there now as delocked the car so where does the other end of the rod go to its the short one with the yellow clip any ideas
[Edited on 01-12-2008 by dangsi]
[Edited on 01-12-2008 by dangsi]
|
luke85
Member
Registered: 26th Nov 07
Location: Chesterfield
User status: Offline
|
If your fitting handles without locks then remove the rod, the other end should just unclip
|