c20kenny
Member
Registered: 12th Jun 08
Location: Cumbria
User status: Offline
|
as above can i use equal length shafts as my gearbox is ment to have the conversion but when i put it in reverse and reverse about a foot it makes a whining noise pull it forward and it shuts up. any help would be appreciated.
|
c20kenny
Member
Registered: 12th Jun 08
Location: Cumbria
User status: Offline
|
anyone ?
|
andyc1234
Member
Registered: 7th Nov 06
Location: Lancashire
User status: Offline
|
reverse normally does whine
|
Nic Barnes
Member
Registered: 5th Apr 04
Location: nowhere near ginger people
User status: Offline
|
id doubt its anything to do with the shafts really.
|
andyc1234
Member
Registered: 7th Nov 06
Location: Lancashire
User status: Offline
|
the 2wd drive kit wont make it whine either all it is is a spacer plate nothing mechanical.
|
c20kenny
Member
Registered: 12th Jun 08
Location: Cumbria
User status: Offline
|
its only a foot though it sounds as if the slines on the driver side shaft are just to big and it spins in side the cog. would it do it if the clucth was slightly out of line.
|
andyc1234
Member
Registered: 7th Nov 06
Location: Lancashire
User status: Offline
|
clutch cant be out of line. even if it was a bit out when it was fitted it would line up as soon as you press the clutch pedal. splines wouldnt be slipping you would know about it if they were it would do it all the time
|
