dalejones
Member
Registered: 9th Dec 08
Location: Swansea, Wales
User status: Offline
|
bought some bonnet lifters but they didnt come with fittin instructions, can n e one tell me where they bolt to are there holes already there or can someone tell me the measurments that locate the holes so i kno exactly where to drill to bolt them on correctly? cheers
|
Ste
Premium Member
Registered: 5th Mar 03
Location: Taif, Saudi Arabia
User status: Offline
|
have you looked at the related links below?
I would rather lose by a mile because i built my own car, than win by an inch because someone else built it for me.
|
Corsa-crAnk
Member
Registered: 18th Aug 09
User status: Offline
|
Step 1
Remove the bolt shown in the picture on both sides of the front wings (just in front of the suspension turrets). Be careful not to remove the wrong one or your bonnet won't close.
Step 2
Remove the securing bolt on the bonnet. Your instructions may say either the top or bottom bolt.
Step 3
Get the bolts and washers.
One should have a large thread(for the front wings), the other should have a fine thread (for the bonnet hinge).
Step 4
Screw the large thread bolt into the hole where the wing bolt was removed, and remember to use the washer supplied.
Step 5
Once the bolt is threaded in place, tighten it up with a spanner, remember not to overtighten it.
Step 6
Thread the finer threaded bolt into the hole on the bonnet hinge and again tighten up with a spanner.
Step 7
Gently remove the wire circlips from each end of the lifter and dab some grease into the ball housing on either side.
Step 8
Push the fat end of the bonnet lifter into the top ball bolt located on the bonnet hinge. You may need to push hard.
Step 9
Now push the thin end of the bonnet lifter onto the ball bolt on the wing. Again you may need to push hard.
Step 10
Press the wire circlip into the top part of the bonnet lifter. This will keep the ball in it's joint.
Step 11
Press the wire circlip into the bottom part of the bonnet lifter.
Step 12
Repeat for the other side.
Result
A nice set of shiney bonnet lifters that not only look good, but aid in holding the bonnet up.
|
Corsa-crAnk
Member
Registered: 18th Aug 09
User status: Offline
|
Just done mine this moring!!
|
Corsa-crAnk
Member
Registered: 18th Aug 09
User status: Offline
|
Opps, pictures didnt come up :s
|
dalejones
Member
Registered: 9th Dec 08
Location: Swansea, Wales
User status: Offline
|
done it! piece of piss cheers for the help!
|