shauny bizzle
Member
Registered: 2nd Aug 06
Location: Sheppey, Kent Drives: Vectra GSI V6
User status: Offline
|
Hello im after some rough figures and some ideas too so heres the spec...so far
C16XE Lump Standard ECU
Lightened Flywheel (5kg)
VXPerformance Powerbox
Janspeed Decatted System
Pro-Tech Stainless 4 Branch
K&N Panel Filter/Drilled Airbox
Port Porlished Head -- Soon To Get
Cams - Standard Regrinds From Kent Cams -- Soon To Get
it all in bits atm so no rush for what i can get not ££££s tho dont mind a few £££ lol but what else could i get thats deffo worth doing i think ive covered the majority what people would do,so what BHP am i looking at cheers in advance
Shaun
|
jamesy1990
Member
Registered: 15th Dec 08
Location: fife
User status: Offline
|
your prety much in the same boat as me mate . iv got a x16xe with a 4 branch and a decat gona be fitting mantzel and newman cams get the ecu fitted with a dastek chip and put it in for a map where they will raise the rev limit to 7000rpm and im hopeing to have about 140bhp
|
shauny bizzle
Member
Registered: 2nd Aug 06
Location: Sheppey, Kent Drives: Vectra GSI V6
User status: Offline
|
i was hoping around that with out mapping hahaha well i could put ARPs in just in case i do decide to play with the limiter etc
|
