jo1945
Member
Registered: 15th May 09
Location: Stourbridge, West Midlands
User status: Offline
|
My xe is tapping and generally a bit tired so I was thinking of getting it rebuilt, how much does a rebuild cost roughly and what work goes into it? Thanks.
|
Eck
Premium Member
Registered: 17th Apr 06
Location: Lundin Links, Fife
User status: Offline
|
u2u Philip2 mate. He can sort you out a rebuild!
|
jo1945
Member
Registered: 15th May 09
Location: Stourbridge, West Midlands
User status: Offline
|
cheers, do you know where he's based?
|
Eck
Premium Member
Registered: 17th Apr 06
Location: Lundin Links, Fife
User status: Offline
|
It says N.Wales/Chester in his sig
|
jo1945
Member
Registered: 15th May 09
Location: Stourbridge, West Midlands
User status: Offline
|
nice one not too far from me then
|
sparkyunlimited
Member
Registered: 30th Dec 04
Location: Cleveleys, Lancashire
User status: Offline
|
I had my xe rebuilt - new bearings and gaskets throughout.. bores honed, new rings, stem seals, pressure tested head... i dropped the engine off to them half stripped and picked it up rebuilt... total cost was just short of £1200!
|
jo1945
Member
Registered: 15th May 09
Location: Stourbridge, West Midlands
User status: Offline
|
ouch, I was hoping to pay that for them to do everything oh well, might have to wait another month or 2
|
philip2
Member
Registered: 1st Oct 06
Location: n.wales/chester
User status: Offline
|
Fuk me thats xpensive, I could do a rebuild with portd head and prob pistons for 1k or so! Haha, I mustnt be charging enough obviously! Oh and if u have u2u'd me il try get it tonight ive got 7 to reply too now but not been near comp for 3wks.
Rebuild if bores are ok is usualy:
Strip down, everything chemicaly cleaned, crank checked/polished. I use ACL 780 big ends and mains, mahle or ks rings. Bores honed, new oil pump, water pump, gates belt kit if early type, cant think of make I use for late type now though. Elring gasket sets top and bottom. Head stripped, guides checked, decoked, valves cleaned and ex valves recut. New seals and light skim, and rebuilt. Ready to go.
Obv depending on budget, I can build from stock to all steel jobby
[Edited on 05-04-2010 by philip2]
|
jo1945
Member
Registered: 15th May 09
Location: Stourbridge, West Midlands
User status: Offline
|
Yeah, I've u2u'd you. I'm not in a massive rush to get it done but if it goes through it's mot next week, it'll be in the next month or so.
It seems solid enough atm, but as I've said it does tap quite a lot when cold, it's a bit smokey and it idles a bit rough. Not sure what that's down to though.
|
philip2
Member
Registered: 1st Oct 06
Location: n.wales/chester
User status: Offline
|
Idle may just be sensor. Smoke may be ring or seals, but id gues ring but without stripping I couldnt tel you for def
|
jo1945
Member
Registered: 15th May 09
Location: Stourbridge, West Midlands
User status: Offline
|
ok, I'll get back to you once the mot man has done his worst.
|