SEAN_P_
Member
Registered: 30th Nov 09
Location: *Washington*North-East*
User status: Offline
|
Hello all
I have finally completed my c16xe rebuild 
During the build i changed the engine loom as the one Which
was on was proper hacked into bridged across ect
I got my new c16xe loom off a mate which was perfect
no wires cut or anything i stripped everything off it to check.
Anyway i fitted the new loom to the engine but there was no plug
for the throttle position sensor.
my old butcherd loom 3 wires cut off the injector loom plug
(the one with the brown rubber one)(blue,yellow/green,yellow/black)
and it had a plug wired in so that the throttle position sensor was working.
Does anyone know or done something about this
cheers SEAN_P_
|
andyc1234
Member
Registered: 7th Nov 06
Location: Lancashire
User status: Offline
|
the tps wiring is a bit dodgy on the standard loom it always looks like someones bodged an extra wire into something but thats how they come
|
alan-g-w
Member
Registered: 9th Nov 07
Location: Glasgow
User status: Offline
|
How the fuck is there an owl sitting on the head of an engine in your avatar 
|
SEAN_P_
Member
Registered: 30th Nov 09
Location: *Washington*North-East*
User status: Offline
|
Haha its my dads owl hes got two they kept
me right during the built
As for the throttle position thing i bridged into them wires off the injector loom and its working mint. Just wondered if anyone else had issues with this.
|
