bally2010
Premium Member
Registered: 2nd Mar 10
Location: Manchester Drives: Punto Grande Rides: Runner 17
User status: Offline
|
my car has been running lumpy but not lost too much power , eml constant on until today , put foot down through gears and it went off its stayed off  but still runs bit lumpy think sounds lumpier as exhaust is blowing abit
but when i flashed codes up
i got code 24 - No speed signal or low voltage , but my speedo works ? how do i sort this out ?
i got 34 - Manifold Absolute Pressure (MAP) sensor- Low voltage ? again how do i sort this out ?
i got 35 - Idle stepper motor - Poor or no idle speed control , if i type idle stepper in ebay it comes up with a i.c.v which i have changed how do i fix this also ?
i have heard if i take my battery wires off and leave overnight that it should reset the ecu or something is this true, if not can someone point me in right direction to reset ecu so then i can start engine again and see what codes get flashed up
[Edited on 01-03-2011 by bally2010]
|
