Geddes6866
Member
Registered: 27th Sep 10
Location: Errol, Perth and Kinross
User status: Offline
|
hi guys i posted a while ago about a big brake conversion and it was just said to be bolt off bolt on . but i discovered my brake hoses were too short . so after getting longer ones i managed to snap the pipe so i made new pipe and still no brakes . i fitted a new servo, master and bottle . still nothing . then another master cylinder . nothing .. i then replaced the 2.0 brakes back to my old 1.0 brakes and everything was back to before but had no brakes still ... there is definetly no air in system they have been bled about 20 times litterally . when i pump the pedal up i get a hard pedal but if i take my foot off the brake pedal and then re apply it the pedal goes back to the floor. i have taken the callipers off and made sure the piston is coming in and out both on and off the car and they are . almost seems like its pulling itself too far back in. my car now has new brake pipes,hoses,fluid and is back on the 1.0l brake discs callipers and pads . deos anyone have anything that could help me ?
sorry for the essay just done so much and got no where ..
Regards
Ross
|