-Aliba-
Member
Registered: 15th Apr 02
Location: Ayrshire
User status: Offline
|
When i remove the pin that holds the rev counter needle at o revs, should the needle remain there, or should it rotate to aroung -1000 revs???
|
-Aliba-
Member
Registered: 15th Apr 02
Location: Ayrshire
User status: Offline
|
c'mon bloody help me here
|
Mikorsa16v
Member
Registered: 2nd Sep 02
Location: Burgess Hill, West Sussex
User status: Offline
|
no that is what the pin is for, to stop it falling below
|
Mikorsa16v
Member
Registered: 2nd Sep 02
Location: Burgess Hill, West Sussex
User status: Offline
|
so it sounds normal even though i havnt tried it, thats why there is a stop pin i think 
|
-Aliba-
Member
Registered: 15th Apr 02
Location: Ayrshire
User status: Offline
|
kinda thot that, but the next question was how far it drops. Just hoping someone has a set of dials sitting in their room.
|
DJP
Member
Registered: 27th Oct 02
Location: Stoke on Trent
User status: Offline
|
why do you need to take it off? as far as i knew it didn't come off at all... but the nova dial kit's used to drop to about -1000... there was a way to put the needle back on without screwing the accuracy up... but i can't remeber... sorry mate.
|
-Aliba-
Member
Registered: 15th Apr 02
Location: Ayrshire
User status: Offline
|
cheers mate, monte gracious
|
