Corsa_Sport21
Member
Registered: 13th Apr 08
Location: Leven, Fife. Drives : 205 GTi
User status: Offline
|
Right, after removing the rear boot strip on my 206 (P1 with the badge in favour of a P2 strip without the badge) ive noticed that the badge has left a sort of step down in the paint/lacquer.
Now is it possible to remove this (or most of it) and blend it in with some fine wet and dry??
|
Jed D
Member
Registered: 15th Mar 11
Location: Durham
User status: Offline
|
really good polish. wet and dry maybe
|
mattfiesta
Member
Registered: 14th Jul 05
Location: Nottinghamshire
User status: Offline
|
Sounds like the cars had a quick respray and they haven't bothered to remove the trim, I'd put the old trim back on and leave it be.
|
Twiggy
Member
Registered: 15th Oct 04
User status: Offline
|
yeh not worth the hassle for a badge
|
Corsa_Sport21
Member
Registered: 13th Apr 08
Location: Leven, Fife. Drives : 205 GTi
User status: Offline
|
Its not bad enough to bother me tbh, but is noticeable when up close.
Might try a bit T-cut or some cutting compound.
|
Liam-Wilko
Member
Registered: 6th Mar 08
Location: Sunderland, Tyne and Wear
User status: Offline
|
if it dosnt bother ya mate id just leave it it mite fade over time and a few washs
|
Bonney
Member
Registered: 14th Nov 04
Location: St Helens
User status: Offline
|
Use some 1500 wet and dry wet then give it a good polish up with some g3 on a buffer and then polish with your choice of polish.
|
belton
Member
Registered: 23rd Jul 09
Location: Kent
User status: Offline
|
if the car is silver just 2000 wet it down and use an aggressive compound like G3,
If you have an little local bodyshops just run in and ask if someone could polish it out for like a tenner as bottle of g3 is fairly expensive
|