cunningham
Member
Registered: 25th May 05
Location: Lochore, Fife
User status: Offline
|
Anything I can buy that's been tried and tested?
|
John
Member
Registered: 30th Jun 03
User status: Offline
|
What kind of join?
|
cunningham
Member
Registered: 25th May 05
Location: Lochore, Fife
User status: Offline
|
Dunno what you call it its 15mm pipe cold water tap at kitchen sink new taps have flexi with bit on the end that's all fine it's the copper pipe end. Think it's cause it's maybe to close to a bend
|
Rob_Corsa
Member
Registered: 4th Apr 02
Location: Derbyshire
User status: Offline
|
If its a fitting with an olive in that's leaking you can undo the nut, wrap PTFE tape around the olive and tighten the nut back up. There's also a paste you can buy that you cover the inside of the fitting with and then tighten up.
|
mattk
Member
Registered: 27th Feb 06
Location: St. Helens
User status: Offline
|
nothing I can recommend other than just fix it I suppose, if its a solder joint, cut it out and replace it, if its a nut and cone then try and tighten it or tape it up
|
cunningham
Member
Registered: 25th May 05
Location: Lochore, Fife
User status: Offline
|
Fixed it. Took it apart and applied some Fernox ls-x to the olive and nipped it up again no more leaks
|
