Dave_1987
Premium Member
Registered: 27th Dec 11
Location: Cumbria
User status: Offline
|
Hi all. I have got an L reg corsa with the early front suspension set up and I have been at work tonight trying to fit my new bushes. I have got the poly race ones from rally design. I have fitted them into the suspension arms and the the front tie bar brackets but when I bolt the arm on the tie bar bracket bolt holes are about half an inch out or if I put the tie bar bolts in first the I cant get the arm in.
I cant work out where I am going wrong it just wont fit. I had to down tools in a strop like a kid and leave my car on the lift in the hope someone has had this issue before and its easy to sort or have I done something wrong.
Any help or comments would be appreciated.
|
Dave_1987
Premium Member
Registered: 27th Dec 11
Location: Cumbria
User status: Offline
|
Is no one using the poly race tie bar bushes or has had no one had this issue before.
|
carl roper
Member
Registered: 17th May 09
Location: Newport Shropshire
User status: Offline
|
You need to bolt it
Loosely to the lower arms then use a pry bar and leaver it into position to bolt up to on the cross member
|
Dave_1987
Premium Member
Registered: 27th Dec 11
Location: Cumbria
User status: Offline
|
Thanks mate. Did you have this problem?
|
carl roper
Member
Registered: 17th May 09
Location: Newport Shropshire
User status: Offline
|
Yes even worse my tie bars had been machined down to give extra castor
|
