corsaboynick
Member
Registered: 29th Mar 02
Location: Derby Uni
User status: Offline
|
I start my engine it turns over fine runs fine touch the accelerator and it starts juddering, turning over slowly and engine stalls as if not enough or too much fuel is getting into cylinders turn it back on and it starts reving at bout 2000rpm then touch the accelerator again and engine stalls. As its an intermittent fault its hard to determine what it is without taking everything apart just wondering if anyone else has had this problem and what did you do to sort it out?
Cheers Nick
|
sunnyb
Member
Registered: 21st Oct 03
Location: Kent, near Bluewater
User status: Offline
|
let it idle for a few mins thats what happens to mine pain in ze arse mate
|
corsaboynick
Member
Registered: 29th Mar 02
Location: Derby Uni
User status: Offline
|
had been ideling for about 10 mins cos i was deicing my car at the time. Do you have this problem regularly then?
|
sunnyb
Member
Registered: 21st Oct 03
Location: Kent, near Bluewater
User status: Offline
|
all the time but if i let it idle for a min or 2 then its fine! im not very mechanical but that happens to mine! but after 10mins should be sweet!
|
sunnyb
Member
Registered: 21st Oct 03
Location: Kent, near Bluewater
User status: Offline
|
greasemonkeys good for that kinda stuff ask him buddy
|
corsaboynick
Member
Registered: 29th Mar 02
Location: Derby Uni
User status: Offline
|
ok cool cheers for your help
|
whitter45
Member
Registered: 15th Nov 02
Location: Norton
User status: Offline
|
have u got an induction kit on the engine.
Mine started to judder when i fitted the induction kit.
The only way i stopped it was to tape up the end of the red wire that used to lead to the side of the airbox as i could feel it sucking in air (if u understand what i mean)
|
corsaboynick
Member
Registered: 29th Mar 02
Location: Derby Uni
User status: Offline
|
no i havent got an induction kit but i know wot bit u mean i might try fiddling with that then next time it starts playing up
|
whitter45
Member
Registered: 15th Nov 02
Location: Norton
User status: Offline
|
ok mate good luck it semed to work for me
|
corsaboynick
Member
Registered: 29th Mar 02
Location: Derby Uni
User status: Offline
|
cheers mate
|
Adam-D
Member
Registered: 11th May 02
Location: Cheshire
User status: Offline
|
check the map sensor pipe this can cause it to cut out also chack all vacumm pipes for splits
amd when was it last serviced air filter and fuel filter
could be blocked
also the injector could be blocked
|
corsaboynick
Member
Registered: 29th Mar 02
Location: Derby Uni
User status: Offline
|
cool cheers il check them out
|
Siberia22
Member
Registered: 23rd Oct 03
User status: Offline
|
i had the same problem with my 1.2 8v. iff you stab the accelerator when stoped it trys to cut out like as if there wasent enough petrol getting through if u push it smoothly its not bad?
When it stalls takes a while to start back up again and sounds rough?
and when it starts back up the revs drift way up then back down again
temp sensor was bust well thats what vauxhall said
got that and the timing belt done at the same time works fine now
so i presume it was the temp sensor.
|
corsaboynick
Member
Registered: 29th Mar 02
Location: Derby Uni
User status: Offline
|
Right ok il look in to it sounds really similar to what mine is doing.
|
dysonm
Member
Registered: 10th Apr 02
Location: Cheshire
User status: Offline
|
had this last month check your plud and clean the caps
|