Matty L
Member
Registered: 10th Aug 04
Location: cheshire
User status: Offline
|
I've decided to amp up my front infinity components.Stipped down the drivers side panels yesterday to get to the door connection plug But instead of putting a brand new cable straight to the components from the amp, i decided to cheat and just use the standard wire inside the door and connect the new wire upto this under the ecu.Ive only just realised that the standard vaxuall cable might not be able to cope with the current from the amp causing a loss in sound quality?, wrong gauge wire maybe i'm getting sound.....and the difference is brilliant....just need this clearing up thanks
[Edited on 13-11-2004 by Matty Lee18]
|
Adam-D
Member
Registered: 11th May 02
Location: Cheshire
User status: Offline
|
now doing that may lose a bit of quality
but-- i did that 
if you have time you can run it throu the plug in the door it just takes time thats all
|
Dom
Member
Registered: 13th Sep 03
User status: Offline
|
tbh, i doubt you will notice any difference mate 
however saying that, i would rather spend the extra hour or two and drill the multiplug and run a single cable from the amp to the crossover etc
|
kev_corsa
Member
Registered: 7th Nov 02
Location: Newport, Uni in Bristol
User status: Offline
|
agree with visible man on this - probaly wont notice the difference
|
mike_1.2LS96
Member
Registered: 23rd Oct 03
Location: Darlington | Mazda 323 1.8 Exec
User status: Offline
|
I put wires running from my doors to the amp in the boot, its much better with thicker wire but is on show when you open the door
|
Matty L
Member
Registered: 10th Aug 04
Location: cheshire
User status: Offline
|
quote:
Originally posted by mike_1.2LS96
I put wires running from my doors to the amp in the boot, its much better with thicker wire but is on show when you open the door
did you take the old vauxall wiring and connection hub out? i have and am now left with 2 big holes which should have grommits on where the old loom went through...the wire shows on mine too...with no water-proofting either on both sides of entry holes into side panal and door....
|
Matty L
Member
Registered: 10th Aug 04
Location: cheshire
User status: Offline
|
quote:
Originally posted by VisibleMan
tbh, i doubt you will notice any difference mate
however saying that, i would rather spend the extra hour or two and drill the multiplug and run a single cable from the amp to the crossover etc
i opted to take out everything between the door & and main frame holes and just have a lone cable running straight through.It works, sound quality is great....well was great....as my amp has now bust! (gain knob caved in) snapping it completely of its circuit inside!....never again infinity amps
|
