WhiteGSI
Member
Registered: 4th Jan 04
Location: Northampton
User status: Offline
|
anyone fitted dial rings to a corsa b? i have some and trying to figure out how get hte clear plastic off the front of the dials area without braeking it. anyone know? any help appreciated
|
j0hn
Member
Registered: 12th Apr 04
Location: Amersham, Buckinghamshire/Kingston-upon-Thames
User status: Offline
|
gotta take the steering wheel surround away (just phillips head screws holding it)
|
MJ
Member
Registered: 18th Sep 03
Location: Hampshire Drives: ITR DC2 + Skoda Felicia
User status: Offline
|
Right i have just done mine
- Start by undoing the 3 screws holding the dial surround, on mine it is silver.
- Then undo 2 small screws that hold the plastic on around where the key goes in. you have to turn the steering wheel 90degress to the left and the right to remove them.
- Then if u look underneath the key lock there are 3 more screws that hold the plastic to the streering collom.
- Then remove the 2 lower plactic bits, they fell like they willl snap but they dont, they will come off. Then remove the surround bit by taking it through the top u have to bend it alittle.
- Once all the plastic is removed ondo 2 screws that hold the dials in. and unclip the top.
- U can either now remove the whole speedo or just the front bit, I did just the front bit. To do this put ur hands behind once u pull the dials out abit and unclip the 4 clips, and then the front comes off. To make it easyer pull the millege reset pin out.
- Now is the fun bit, getting the rings in. The smaller ones are easy as u just put them in through the bigger holes. For the large ones. split the seal along the top then open it abit and slide the rings in through the top.
- Use superglue to stick the rings in and to seal the dial back together.
- Then fitting is the reverse.
Any Questions Just ask.
Sos about the spelling
This is wot mine looks like
|
j0hn
Member
Registered: 12th Apr 04
Location: Amersham, Buckinghamshire/Kingston-upon-Thames
User status: Offline
|
cool!
|