Dave A
USER UNDER INVESTIGATION - DO NOT TRADE
Registered: 10th Dec 03
Location: County Durham
User status: Offline
|
pics of corsa gear linkages wanted.
i bought a short shift gear linkage from lmf. took the old one off the rear mounting, noted how it went together, took it apart, forgot how it went together , sat for an hour trying, but there is so many ways it could go!
anyone got any pics, or know how it goes together?
kept thinking "ive just re-built a fookin engine, how hard can a linkage be"
|
Twiggy
Member
Registered: 15th Oct 04
User status: Offline
|
I wud like to see aswell!!!!
|
James R
Member
Registered: 4th Feb 03
Location: 205GTi16/306GTi16
User status: Offline
|
you have the S section. this has the 2 plastic cups in with the metal shaft down the middle.
Then you have the two bits with the O on the engine.
the but with the knurling on that slides in to the shift shaft. and the other end with the rubber block in.
You clip the plastic bucket over the ball on the S section
Then slide the O of the end on.
Then add the circlip in to hold them in place simple.
Let me know if I missed a bit
|
Dave A
USER UNDER INVESTIGATION - DO NOT TRADE
Registered: 10th Dec 03
Location: County Durham
User status: Offline
|
thanks for the reply, but doesnt help much. i think i need some pics
|
Dave A
USER UNDER INVESTIGATION - DO NOT TRADE
Registered: 10th Dec 03
Location: County Durham
User status: Offline
|
i dont know which end should be where, and which way up it goes!
|
James R
Member
Registered: 4th Feb 03
Location: 205GTi16/306GTi16
User status: Offline
|
look at the S section you just took off. which side is dirtier??
that's the top face.
|
Dave A
USER UNDER INVESTIGATION - DO NOT TRADE
Registered: 10th Dec 03
Location: County Durham
User status: Offline
|
thanks. ill get the linkage tomorrow and post some pics, then youll know what im on about
|
