corsapower
Member
Registered: 9th Aug 04
Location: near bridlington
User status: Offline
|
ive just been trying to wire my digi dash in i tried to start the engine to chack the rev counter etc worked, and bang looks and its blown a hole in the sump and cracked it, the fcambelt looks ok tho, does this mean new engine time.
cheers
|
Jake
Member
Registered: 24th Jan 05
User status: Offline
|
it means new sump time
|
broster
Premium Member
Registered: 6th Dec 02
Location: Drives: E39
User status: Offline
|
whats made the hole in the sump, a piston?
|
corsapower
Member
Registered: 9th Aug 04
Location: near bridlington
User status: Offline
|
i dont have a clue i just went to start it and it went bang and i looked and there is a hole the size of a five pence peice a crack and oil dripping everywhere, the engine has only done 42 thou, if its a piston is it another new engine time.
|
X 60RSA
Member
Registered: 20th Aug 01
Location: Lincoln
User status: Offline
|
Take of the sump and have a good look in it for any metal particles, im guessing something has come off, unlikely a hole would just occur from starting up your engine.
|
Jake
Member
Registered: 24th Jan 05
User status: Offline
|
could an electric surge cause something like that?
|
X 60RSA
Member
Registered: 20th Aug 01
Location: Lincoln
User status: Offline
|
Doubt it but who knows! Even if the sump was weak in 1 area, i cant see it blowing open on start up...
|
corsapower
Member
Registered: 9th Aug 04
Location: near bridlington
User status: Offline
|
ok i will check i havnt tried to turn the engine over just in case it is repairable dont want to do any more damage, well its looks like the 1.8 engine mite be going in after all. cheers
|
ainsley_brader
Member
Registered: 24th Mar 02
Location: Tattershall, Lincolnshire
User status: Offline
|
think the digi dash bit must be pure coincidence.
Most likely its chucked a rod and is scrap!
|
Dave A
USER UNDER INVESTIGATION - DO NOT TRADE
Registered: 10th Dec 03
Location: County Durham
User status: Offline
|
conrod snapped
|
corsapower
Member
Registered: 9th Aug 04
Location: near bridlington
User status: Offline
|
bad then can it be rebuilt if the crank has snapped or will it cost a lot i do have a 1.8 16v engine if i need another one.
i will check it out 2 moro and see what it looks like .
cheers
|
Adam-D
Member
Registered: 11th May 02
Location: Cheshire
User status: Offline
|
yup i think its thrown a rod mate
|
corsapower
Member
Registered: 9th Aug 04
Location: near bridlington
User status: Offline
|
ive stripped it and its snapped a con rod to 1 of the pistons, would it be possible to rebuild it the ingine wasnt running when it snapped so hopefully it wont have done much damage.
cheers
|
Stu_22
Member
Registered: 25th Mar 02
Location: Luton
User status: Offline
|
Easier to just swap engines
|
miles
Member
Registered: 25th Mar 02
Location: plymouth Drives: Astra Sport
User status: Offline
|
quote: Originally posted by corsapower
]the ingine wasnt running when it snapped so hopefully it wont have done much damage.
The engine was just sat there and it threw a rod through the sump without moving?
|
Corsa_B1.2
Member
Registered: 26th Feb 04
Location: Greenock, Inverclyde
User status: Offline
|
42,000 miles has the timing belt been changed?
|
corsapower
Member
Registered: 9th Aug 04
Location: near bridlington
User status: Offline
|
the timing belt was change 3 thousand miles ago with the pulleys, i was trying 2 start it and it fired then went bang but it wasnt running properly
|
mikehiow
Member
Registered: 12th May 05
User status: Offline
|
you wire the dash in wrong or short something, possibly affecting fueling or something similar? maybe that caused it
|
corsapower
Member
Registered: 9th Aug 04
Location: near bridlington
User status: Offline
|
hmm possible
|
mikehiow
Member
Registered: 12th May 05
User status: Offline
|
just had this thought of too much fuel and pre-ignition blowing the rods through the bottom probably totally unlikely, did the dash work in the end?
|
ShEp
Member
Registered: 9th Aug 05
Location: Dingwall, Highland
User status: Offline
|
my old 2.0 8v corsa threw a leg outta the bed (con-rd thru the block) at 130 
|
corsapower
Member
Registered: 9th Aug 04
Location: near bridlington
User status: Offline
|
ive got most of it working just not speedo n oil pressure dont know if temp works either
|
miles
Member
Registered: 25th Mar 02
Location: plymouth Drives: Astra Sport
User status: Offline
|
no wiring fault will snap a rod.
|
Ant
Member
Registered: 12th May 02
Location: Hereford and Worcester
User status: Offline
|
well cant see you having much oil pressure now anyway!!
If i were you i would fit the other engine (is this one good??) it may have caused damage to the bore the valves guides, crank and so on it would prob be best to budget for a complete rebuild.
|
mikehiow
Member
Registered: 12th May 05
User status: Offline
|
quote: Originally posted by miles
no wiring fault will snap a rod.
yet its known for an incorrect remap to blow a piston into dust......
Some how I think it is atleast possible.
|