CoastalCorsa
Member
Registered: 7th Jan 05
Location: Lancashire
User status: Offline
|
I have done a search but did not get much info on how to actually do the conversion
what bits do i need and how do i go about fitting them
Help much appreciated Thanks In advance 
|
flash22
Member
Registered: 13th Sep 05
User status: Offline
|
motor,cover,bit of the loom with the plug on it and the switch. the vectra one has closure on it whats a bonus can be had of ebay for around £20-30
as for fitting it a piece of p*** take out the old winder cover and mech put the motor in place held up by 2 screws .screw it up wire it up trim the cover up and install that. do as search all the info is on here. the bigest job is the wiring and thats only 4 wires 1 ground,1 perm live,1 swich live and 1 for the closure
|
VegasPhil
Premium Member
Registered: 16th Jan 05
Location: Fareham, Hants Drives: Octavia VRS
User status: Offline
|
Presume you could get the motors etc out of an Astra, Vec, Omega.
Don't know about the wiring and how you would mate that up to the Corsa's Loom.
AFAIK no Corsas came with Electric Sunroofs.
Corsa 2.0 16v Vegas - Sold
|
CoastalCorsa
Member
Registered: 7th Jan 05
Location: Lancashire
User status: Offline
|
spot on if any one knows the exact link for the wiring i would appreciate it if ya can post it up here as i can not find out via search maybe i am blind
|
flash22
Member
Registered: 13th Sep 05
User status: Offline
|
the vectra b motor and cover fit as i said above as for the wiring
1.ground run that down the a piller and ground it there (beside the glove box)
2. switch live this can be found in the loom what runs under the glove box (black/violet wire)
3.perm live (fuse @ 20amp) either staight from the battery or off the back of the ignition switch (heavy red wire)
4.closure goes to your alarm or remote locking module
|
flash22
Member
Registered: 13th Sep 05
User status: Offline
|
this is a guide to the mk3 astra only difference is you dont need to cut the motor casing!!!!!
basicly the same setup
http://82.34.50.33/sytemsandsoftwaredevelopment/systems/automotive/How_to/Astra3/VectraSunroof.htm
|
flash22
Member
Registered: 13th Sep 05
User status: Offline
|
And some info on cutting the vectra cover to fit is here.... http://www.corsasport.co.uk/board/viewthread.php?tid=267401
[Edited on 06-03-2006 by flash22]
|
CoastalCorsa
Member
Registered: 7th Jan 05
Location: Lancashire
User status: Offline
|
Spot on again people thank you all V much
|
50Calibre
Member
Registered: 13th Dec 04
User status: Offline
|
to ground instead of runnin it down the pillar there should be a bit metal bolt under where the light it with a brown wire wrapped round it.. use that
|
CoastalCorsa
Member
Registered: 7th Jan 05
Location: Lancashire
User status: Offline
|
cheers
|
