corsa col
Member
Registered: 27th Dec 03
Location: Cumbria
User status: Offline
|
Simply question...... are there any horse power waiting to be unleashed by fitting vernier pulleys to a standard cam set-up?
Answers can be as simple or complex as you want!!
|
Ojc
Member
Registered: 14th Nov 00
Location: Reading: Drives : Clio 197
User status: Offline
|
No
|
corsa col
Member
Registered: 27th Dec 03
Location: Cumbria
User status: Offline
|
That'll do!!
Thanks
|
Dave A
USER UNDER INVESTIGATION - DO NOT TRADE
Registered: 10th Dec 03
Location: County Durham
User status: Offline
|
infact there is on most engines. as long as you map the ignition timing to suit.
by adjusting the cam timing on a c16xe just slightly, 5bhp can be had without any other engine mods.
|
corsa col
Member
Registered: 27th Dec 03
Location: Cumbria
User status: Offline
|
Mmmmmm!..... well I already have a mbe mappable ecu setup running jenvey tb's. So on a x14xe do you think i could i expect a similar 5bhp increase then?
|
eiwan
Member
Registered: 18th Oct 05
Location: Finland
User status: Offline
|
quote:
Originally posted by Dave A
infact there is on most engines. as long as you map the ignition timing to suit.
by adjusting the cam timing on a c16xe just slightly, 5bhp can be had without any other engine mods.
Does anyone know which way to adjust the pulleys to achieve this ? I´m going to map my megasquirted c16xe properly soon, so might as well get some verniers and do them also. Any experiences ?
|
Dave A
USER UNDER INVESTIGATION - DO NOT TRADE
Registered: 10th Dec 03
Location: County Durham
User status: Offline
|
I have it written down somewhere, im sure its inlet cam advanced 3-5 degrees, Ill have a check
|
CorsaGSI_DK
Member
Registered: 10th Jun 02
Location: Copenhagen, Denmark
User status: Offline
|
quote:
Originally posted by Dave A
I have it written down somewhere, im sure its inlet cam advanced 3-5 degrees, Ill have a check
I would also like to know :-) Just a simple guideline. Mine will be remapped on a rolling road...but always nice to know some app. setting so we know where to start
|
Warren G
Member
Registered: 14th May 06
Location: Kent
User status: Offline
|
quote:
Originally posted by Dave A
I have it written down somewhere, im sure its inlet cam advanced 3-5 degrees, Ill have a check
would be nice to know, will be fitting pulley with 265 degree cams running megasquirt, when you find out can u u2u me
|
