alistairolsen
Member
Registered: 21st Jan 06
Location: glasgow
User status: Offline
|
Im trying to remove the rear seats in my corsa. Theyre the split fold type. The inner hinges were simple enoug, with obvious torx fixings, but I cant see how the hinges ahead of the wheel tubs work and haynes is VERY vague.
Anyone shed any light?
[Edited on 17-12-2006 by alistairolsen]
|
crazycorsa19
Member
Registered: 24th Jun 06
Location: south
User status: Offline
|
there is a bracket on the floor were they split and one each side at the bottom. both use torque heads i belive
|
alistairolsen
Member
Registered: 21st Jan 06
Location: glasgow
User status: Offline
|
its the ones on each side, I assume you have to remove the plastic cover trim, but you cant get it off because the seat hingre runs thru it?
|
Dazze_b
Member
Registered: 19th Dec 06
Location: manchester
User status: Offline
|
yes m8 u have to remove the plastic covers they have one posi drive screw in each one near the bottom of the plastic then flod the seats forward and pull the plastic covers out and undo the torque screw and ya seats are out
|
crazycorsa19
Member
Registered: 24th Jun 06
Location: south
User status: Offline
|
yep as Dazze_b sais!! its easy mate
|
alistairolsen
Member
Registered: 21st Jan 06
Location: glasgow
User status: Offline
|
got there in the end! After I actually looked at them in daynight I could see how the trim came off and I found the bolts!! Easy peasy, altho haynes description is RUBBISH!!
|