austen
Member
Registered: 9th Jun 07
Location: midlands
User status: Offline
|
Ok I've been pondering on this for a while and i've never posted an add for a car before so bare with me!
I'm only guaging interest at tho mo, but if you're interested get in touch.. pm is probably best
* The chassis is (or was) a 95' M reg SRI which has done 65k
* The interior has been stripped out and had a 'Safety Devices' roll cage welded in, 2 harnesses and 2 bucket seats put in, the only thing that remains is the dash and the front half of the carpet..
* Has been lowered 40mm on bilstein shocks and springs which haven't been on the car for more than 1000 miles (will also supply 60mm springs)
* Brand new re-furbished speedlines in white and brand new tyres, done less than 50 miles
* An after market steering wheel and boss, same color as the harnesses
* Smoked side repeaters
* Gear stick lock (although i don't have the lock, but thats hardly difficult to get)
* Vectra door handles (so no locks for thieving little badgers to worry about)
* fully re-built xe block before it went in 2k ago, inc. all new belts, new pumps, plugs, leads etc..
* New clutch and a re-con F20 box
* LMF engine fitting kit
* New drive shafts
* New wheel bearings
* Oil cooler
* Cool running thermostat
* New clutch and release bearing
* New bottom ball joints
* New wheel cylinders, drums, shoes and wheel bearings
* Hand built tubular manifold
* Pacet slim line pro fan
* Crankshaft sensor
* Water temp sensor
* Bottom pulley
* Lambda sensor
* I have also put twin Webber carbs on her and she has been fully set up by Auto Diagnostics Center (Bullwell)
* 288mm discs and V6 calipers (both less than 1k on them)
* OMP rear strut brace
* Cat 1 alarm and immobilizer both on different systems (same make)
*I also have a few spares to go with, erm.. a set of vectra alloys, mint but need a clean, black and silver no. plates, chrome lower roll bar, chrome battery cover, spare rocker cover in white, 2 x12" subs and 2 x amps to power with all cables etc..
* JVC head unit (face-off)
* Another set of wheel nuts
* A few random bits..(m-tec power cap inj rail, icv.. basically what came off when the carbs went on, just want rid of the lot with the car)
* All wiring was taken out as it was not needed when the carbs went on so there is no rev limiter, this is not a problem as i don't take it that far, but there not expensive if you wanted to fit 1
* I also have a smooth post 97 front bumper in primer waiting to be sprayed
Thats all i can think of at the mo..but i'm sure theres more
Body wise theres a little bit of rust mainly on the bonnet, and tailgate, and a little around the bottom of the doors, but i will supply 5L of paint with the car for who ever gets it, to re-paint the whole car, thats enough to re paint 2 corsa's inside and out!! (and about £200 worth of paint)
Just taxed for 6 months
M.O.T until November
As you can see she has not really been built for looks, just as I go along and I see something i like i buy it. so my personal taste really
She made 187 bhp when she was set up and only covered approx 2k since
As an on going project I've decided enough is enough and I need to stop spending money on my car and buy a house.
I already have another car so I'm not looking for a swap, just a little of your hard earnt..
Any info required just drop me a pm and I'll be happy to answer anything you have to ask
As forum rules state I need to put a base price, I know I'm never going to get close to what she has cost me but if i say £2300 without the speedlines or £2500 with think that would be a fair price.
And please no stupid comments.. if i don't sell I'll quite happily just garage her until i find a suitable let.
Thank you for looking
Austen
[Edited on 08-08-2007 by austen]
[Edited on 11-08-2007 by austen]
[Edited on 11-08-2007 by austen]
[Edited on 12-08-2007 by austen]
[Edited on 13-08-2007 by austen]
|
austen
Member
Registered: 9th Jun 07
Location: midlands
User status: Offline
|
oh i have the caps for the wheels too, just not got round to putting them on
|
John G
Member
Registered: 18th Jul 05
Location: Wirral, Merseyside
User status: Offline
|
nice car and mods but very much doubt it will fetch 2.5k for an m-reg
around £1800 is more realistic price
|
austen
Member
Registered: 9th Jun 07
Location: midlands
User status: Offline
|
like i said I'm just guaging interest, as i want an mr2 turbo
|
Corsa_Scotty
Member
Registered: 8th Aug 07
Location: Scottish Borders
User status: Offline
|
1 word for this car =SWEET ;D
|
austen
Member
Registered: 9th Jun 07
Location: midlands
User status: Offline
|
cheers pal
|
austen
Member
Registered: 9th Jun 07
Location: midlands
User status: Offline
|
ttt
|
austen
Member
Registered: 9th Jun 07
Location: midlands
User status: Offline
|
lunch time bump
|
austen
Member
Registered: 9th Jun 07
Location: midlands
User status: Offline
|
ttt
|
scoob
Premium Member
Registered: 16th Oct 03
Location: Beverley, E Riding of Yorkshire
User status: Offline
|
any pics of the engine bay?
|
austen
Member
Registered: 9th Jun 07
Location: midlands
User status: Offline
|
yeah i'm just going out to give her a good wash, bare with me..
|
scoob
Premium Member
Registered: 16th Oct 03
Location: Beverley, E Riding of Yorkshire
User status: Offline
|
cheers
|
austen
Member
Registered: 9th Jun 07
Location: midlands
User status: Offline
|
bumpety bump
|
ChrisBoom
Member
Registered: 6th Dec 06
Location: Highland
User status: Offline
|
Carbs 
|
austen
Member
Registered: 9th Jun 07
Location: midlands
User status: Offline
|
the noise on chat is amazing if you throttle it right it sounds like a machine gun, boys and there toys eh.. haha
|
scoob
Premium Member
Registered: 16th Oct 03
Location: Beverley, E Riding of Yorkshire
User status: Offline
|
any proof of rebuild ? what drive shafts is it running? thanks
|
austen
Member
Registered: 9th Jun 07
Location: midlands
User status: Offline
|
200bhp shafts
|
