16V_1600
Member
Registered: 7th Oct 07
User status: Offline
|
I have adjusted the 2 bolts either side at the rear of the bonnet and the bonnet now lines up with the wings etc. However it is still sitting a little bit too high at the front. How can the bonnet be adjusted at the front so that it sits lower down?
I have screwed the rubber stoppers to their minimum and even removed them, still needs to be sat lower.
Thanks.
[Edited on 12-01-2008 by 16V_1600CS]
|
DAZ1985
Member
Registered: 3rd Sep 06
Location: Scholar Green, Cheshire
User status: Offline
|
Theirs no method to it really just piss about till it fits
|
andyc1234
Member
Registered: 7th Nov 06
Location: Lancashire
User status: Offline
|
had a bump ? 
|
16V_1600
Member
Registered: 7th Oct 07
User status: Offline
|
quote:
Originally posted by andyc1234
had a bump ?
I haven't no.
|
STEvieXE
Member
Registered: 21st Jan 03
Location: Ballymena N.I.
User status: Offline
|
adjust the catch in the bonnet.
the rubber grommets after a while will be so low that the bonnet it not touching them, u need to bring the amount the bonnet comes down by adjusting the catch on the bonnet and the using the rubbers at the side to finally adjust it again
|
