Vaux Lad
Member
Registered: 15th Dec 04
Location: Stoke-on-Trent
User status: Offline
|
As above.
Best way i can get them to fit is pulling the entire idle motor and tps wires out the plastic casing, and having them go under and around the throttle body.
And im going need to cut two of the egr wires, and length them doing it that way.
Is there any better way to do it?
Maybe putting the loom through down between two of the bottom inlet runners, and then round and under, to the tb, does that reach????
Id just try it and see, but its pi**ing down atm and dark 
|
andyc1234
Member
Registered: 7th Nov 06
Location: Lancashire
User status: Offline
|
i didnt need to do anything with mine just unlpug the egr and pull the wires across
|
Vaux Lad
Member
Registered: 15th Dec 04
Location: Stoke-on-Trent
User status: Offline
|
But the loom is on the front of the box, and the tps etc are on the back....?
Did you route it down through the middle of the inlet?? And back around to the tb?
|
andyc1234
Member
Registered: 7th Nov 06
Location: Lancashire
User status: Offline
|
if you unplug evrything and untangle it then poke it between the lower inlet there should be enough cable to go underneath and to the tps at the side thats how i did mine. theres plenty of wire its just wrapped round the lower inlet
[Edited on 01-02-2008 by andyc1234]
|
Vaux Lad
Member
Registered: 15th Dec 04
Location: Stoke-on-Trent
User status: Offline
|
Ignore this thread, im a di**head and just realised i forget put the loom back down the inlet to its original position, when i removed it today
Cheers anyway.
|
andyc1234
Member
Registered: 7th Nov 06
Location: Lancashire
User status: Offline
|
|
