SHARPY
Member
Registered: 11th Nov 04
Location: Wigan, Lancs Drove: x14xe Sport
User status: Offline
|
my x14xe runs fine usually on the road, but during a motorway drive the speedo goes haywire (and / or) stops working for some reason.
From then on the car will stall at every junction once off the motorway.
If i leave it turned off for 30 mins or so everything is fine again  
any ideas ?
thanx
|
C2RL R
Member
Registered: 28th Mar 02
Location: Redcliffe, QLD
User status: Offline
|
Crankshaft position sensor. i've had very similar symptoms to that and it cured it.
|
SHARPY
Member
Registered: 11th Nov 04
Location: Wigan, Lancs Drove: x14xe Sport
User status: Offline
|
Is it in an awkward place or easily removed matey?
|
byrnie_2004
Member
Registered: 11th Mar 07
Location: Marple, Greater Manchester
User status: Offline
|
i had the same problems, check your earths are all tight. turned out my main earth near the battery had worked loose.
|
SHARPY
Member
Registered: 11th Nov 04
Location: Wigan, Lancs Drove: x14xe Sport
User status: Offline
|
Thanx ill give it a go 
|
Gareth F
Member
Registered: 16th Jan 08
Location: Location Location
User status: Offline
|
Could be the sensor to your gearbox, mine fully snapped off and the speedo didnt work at all which caused the stalling. Check all of above first tho as yours is still working a little bit.
|
Warren G
Member
Registered: 14th May 06
Location: Kent
User status: Offline
|
not crankshaft
if the ecu detects no speedo reading, at junctions it will cut out due to it doesnt no weather the cars moving and doesnt enable the iac valve adjust ment
first thing id do is change the electronic speedo sensor in the gearbox
|
