shultsy12
Member
Registered: 27th Oct 06
Location: Hemel Hempstead, Hertfordshire
User status: Offline
|
right been having a few probs with the valver, engine management light keeps coming on when you drive the car nicely changing gear below 3.5rpm but if u give it some welly doesnt come on at all! any way took it down to get it plugged in on bosch diagnostics comes up with faulty knock sensor and faulty reading from crank shaft sensor, i then changed both of them and still got the same problem............ is there a specail way to put the knock sensor on its torqued up correctly at 25nm, can anyone shed any light?
|
andyc1234
Member
Registered: 7th Nov 06
Location: Lancashire
User status: Offline
|
reset ecu after changing bits?
|
shultsy12
Member
Registered: 27th Oct 06
Location: Hemel Hempstead, Hertfordshire
User status: Offline
|
yup done that forgot to say!
|
andyc1234
Member
Registered: 7th Nov 06
Location: Lancashire
User status: Offline
|
hmmm . is crank sensor aligned properly. correct gap?
|
andyc1234
Member
Registered: 7th Nov 06
Location: Lancashire
User status: Offline
|
ignore me just remembered its in the block
[Edited on 11-03-2009 by andyc1234]
|
shultsy12
Member
Registered: 27th Oct 06
Location: Hemel Hempstead, Hertfordshire
User status: Offline
|
anyone????
|
--ToM--
Member
Registered: 23rd Nov 07
Location: Wirral
User status: Offline
|
maybe its a different fault? sounds like could be landa sensor to me if it goes when giving stick mine used too
|
shultsy12
Member
Registered: 27th Oct 06
Location: Hemel Hempstead, Hertfordshire
User status: Offline
|
when u drive slow the light comes on!
|
Alan-16V
Member
Registered: 5th Apr 08
Location: North Wales
User status: Offline
|
try disconnecting the battery for an hour or so to reset the ecu
|
shultsy12
Member
Registered: 27th Oct 06
Location: Hemel Hempstead, Hertfordshire
User status: Offline
|
done that today still reading the same faults!
|