fazza
Member
Registered: 7th Feb 08
Location: Plymouth
User status: Offline
|
who has fitted these?
need to fit mine but worried about fucking it up
any help appreciated
|
ShEp
Member
Registered: 9th Aug 05
Location: Dingwall, Highland
User status: Offline
|
Want.
|
ShEp
Member
Registered: 9th Aug 05
Location: Dingwall, Highland
User status: Offline
|
oh and u2u luke with the blue c20let he had some fitted iirc
|
fazza
Member
Registered: 7th Feb 08
Location: Plymouth
User status: Offline
|
will call luke later, his mate fitted his though when i spoke to him last week
|
c20kenny
Member
Registered: 12th Jun 08
Location: Cumbria
User status: Offline
|
i fitted mine just measured constantly all the way though
 i think they came out quite well
|
andyc1234
Member
Registered: 7th Nov 06
Location: Lancashire
User status: Offline
|
your best off measuring from a constant point say the corner of the scuttle. decide where you want them on the slam panel. measure from the scuttle and from the wing and do the same again with the bonnet shut. you can measure as many times as you want but you only get one chance to fuck your bonnet up
|
smcGSI16V
Member
Registered: 26th May 03
Location: Farnborough Drives: Thurlby 888 CDTi No.98
User status: Offline
|
I've fitted them.
Piece of piss, just got to make sure they are both lined up exactly the same, angle, width in and up the bonnet, I done it so the centres ran parrallel with the side of the bonnet.
Just take your time.
I used the lump above the light either side for the threaded bolt thing, only thing is that its right at the end of the thread, but the exact right height.
|
