Ant B
Member
Registered: 4th Jan 09
Location: Woodford Halse, Northamptonshire
User status: Offline
|
hi ive had to put my standerd steelis on my corsa so to make them look abit better id quite like a bit of camber if thats posabble thank,
|
Danny W
Organiser: East Midlands
Premium Member
Registered: 14th Nov 05
Location: Northamptonshire
User status: Offline
|
Not sure what the point is in needing camber for wheels that fit perfect  but for the rear wheels you need to space the bottom two bolts out between the rear hub and the beam.
Smoke Grey 5 Door
EastMids Regional Events
|
Ant B
Member
Registered: 4th Jan 09
Location: Woodford Halse, Northamptonshire
User status: Offline
|
i no they fit perfect but i just want abit of camber so it dont look so boring lol ,so as for the rear can i not just put a few washers inbetween the wheel and the hub or not lol
and also im lowerd 50mm at the minit but can i go abit lower on the back with out scrubbing,even tho they have monster truck tyres on lol.thanks m8
|
Danny W
Organiser: East Midlands
Premium Member
Registered: 14th Nov 05
Location: Northamptonshire
User status: Offline
|
You'll need the washers to go between the Hub and the beam which its bolted to so that the bottom of the hub is pushed out, you cant put washers between the wheel & the hub as the wheel will wobble as it spins round.
i've used 1 washer on each bottom bolt, each washer was about 3mm thick iirc which gives me this much negative camber:
I'm not sure how it will effect your tyre wear/drive as your tyres would be pretty narrow on steels but the tyres on my wheels stilll wear fairly even tbh.
Personally the only reason i've used a bit of neg camber is to fit the wheels now i've built them to a wider spec
[Edited on 09-11-2009 by Danny W]
Smoke Grey 5 Door
EastMids Regional Events
|
Ant B
Member
Registered: 4th Jan 09
Location: Woodford Halse, Northamptonshire
User status: Offline
|
ok thanks for that mate do u no if could go any lower than 50 on my stealis
|
Danny W
Organiser: East Midlands
Premium Member
Registered: 14th Nov 05
Location: Northamptonshire
User status: Offline
|
Yeah you should be able to, what size are they? 13"? and what size tyres?
I'm sure you could go quite low on them without too much hassle, i'm using FK coilovers and could go -80mm on my standard 13" steels with the standard size tyre (cant remember the exact size off the top of my head) and it didn't scrub at all as the rolling radius was near the same to a set of 15" wheels running 45 profile tyres 
Smoke Grey 5 Door
EastMids Regional Events
|
Ant B
Member
Registered: 4th Jan 09
Location: Woodford Halse, Northamptonshire
User status: Offline
|
urm yeah there 13'' with 65 profils on i think mate
|
