alan-g-w
Member
Registered: 9th Nov 07
Location: Glasgow
User status: Offline
|
As above - mine was fine until I changed it for a new one, not had a chance to look at it yet, how do I go about sorting it?
|
silvertornado
Member
Registered: 9th Oct 09
Location: nottingham NG5 (east mids)
User status: Offline
|
old push bike tyre cable tied around axle
|
scottyp1989
Member
Registered: 29th Jul 07
Location: Warley, West Midlands
User status: Offline
|
slacken the U clamp, twist the back box and re tighten
|
basslinecorsa
Premium Member
Registered: 15th Jul 09
Location: Gravesend
User status: Offline
|
I cut an exhaust rubber and cable tied it round the beam .... found out my exhaust was hitting the cable that runs along the top of the beam though
Project Scarlett - http://www.corsasport.co.uk/board/viewthread.php?tid=661417
|
alan-g-w
Member
Registered: 9th Nov 07
Location: Glasgow
User status: Offline
|
I should say that it's only been doing this since I replaced my rear beam - I didn't touch the exhaust while I was doing it either.
|
Gareth F
Member
Registered: 16th Jan 08
Location: Location Location
User status: Offline
|
Raise the car on its wheels on a ramp and loosen off all joints then have a play. Its normally the clamp that catches on the beam.
|