Sxi1.2
Member
Registered: 18th Mar 03
Location: Leeds Uk
User status: Offline
|
ive fitted some neons to the underneath of my car.. gow can i get the leads into the inside so i dont have to pop the bonnet every time i want to turn them on
|
Mo
Member
Registered: 29th Jan 03
Location: Bolton, Drives Q3 S-line +
User status: Offline
|
run the wires from the engine bay into the car then put a switch on it.
|
Sxi1.2
Member
Registered: 18th Mar 03
Location: Leeds Uk
User status: Offline
|
ok thats a good idea.. but how do i get the leads into the cabin.. is there somewere i can put the wired through
|
Cybermonkey
Member
Registered: 22nd Sep 02
Location: Sydney, Australia
User status: Offline
|
Through the bulkhead. Shoud be enough room in holes already put there for dash wiring etc.
Dave
|
Skippy corsa
Member
Registered: 27th Jul 02
Location: Sydney, Australia Drives: MY00 WRX Wagon
User status: Offline
|
The black box next to the battery, drill a small hole on the side right near the bottom, go inside the car remove the glove box and you should see a big square hole with heaps of wires coming out of it, you should be able to see your hole. Or you could remove the lid cut a noch out of the box, put the wire in and put the lid back on
|
Mo
Member
Registered: 29th Jan 03
Location: Bolton, Drives Q3 S-line +
User status: Offline
|
on my 1.6 sport i've found 2 entries into the car. the first one in the engine bay is in the far left corner (driver side) and it's quite hard to get to unless u take the scuttle panel off. there should be a grommit there pierce it and run the wire though it. the wires should come out at the foot well of the driver side
and the other one is in the middle of the car underneath the scuttle panel, there's a grommit which u take off and the hole leads to behind the glove box. to access the hole from inside it'll be easier to take the glove box off.
|
Sxi1.2
Member
Registered: 18th Mar 03
Location: Leeds Uk
User status: Offline
|
thanks guys.. ill havea look at that later on.. ps whats a scuttle panel
|
c0r5a_gsi
Member
Registered: 17th Jul 02
Location: Gloucestershire
User status: Offline
|
a scuttle panel is the plastic bit that goes across the bottom of the windscreen, where your wipers mount.
|
Sxi1.2
Member
Registered: 18th Mar 03
Location: Leeds Uk
User status: Offline
|
cheers.. erm is it possible to do this without taking the scuttle panel off.
|
Mo
Member
Registered: 29th Jan 03
Location: Bolton, Drives Q3 S-line +
User status: Offline
|
it is possible but much harder and will probably take u alot longer
|
