corsaadzy
Member
Registered: 6th Aug 09
Location: St. Austell, Cornwall
User status: Offline
|
i just got some bonnet lifters from corsacentre.co.uk .. it came with 2 self tapping bolts and 2 normal bolts all with the ball in the end for the joint obviously
it came with 0 instructions so im just wanderign if anyone can give me a helping guide on how to fit them eg. do the self tapping bolts go at the top or bottom and do i need to get my own nuts to screw on the end?
Adz
|
brebaz
Member
Registered: 11th Dec 09
Location: newcastle
User status: Offline
|
i got them ones and they sent an email witht he instructions:
ADDING GAS LIFT STRUTS TO THE BONNET
This job is very easy and anyone can do it, makes the engine bay a lot nicer place to work.
The bonnet lifters will be near impossible to compress by hand, so don't think they are faulty when you receive them. Once they are installed on the car, the bonnet should lift itself up.
REQUIRED TOOLS : 10mm Open Ended Spanner
TIME REQUIRED : 20 mins
1. Pop the bonnet
2. Starting from the left
3. Tighten the top alignment bolt on the bonnet hinge
4. Remove the bottom bolt on the bonnet hinge(that why we tightened the top ones, so the setting cant change)
5. Screw into these holes the strut ends that have the threaded bolt, tighten with the spanner (hand tight, do not over tighten as bolt will snap), don’t forget to use a washer.
6. Undo the third wing retaining screw.
7. Screw the bolt with the self tapping end into these holes( watch out for wires underneath)
8. Push the thick end of the strut into the top fitting.
9. Get a assistant to lower the bonnet down until the bonnet lifter meets the bolt on the wing.
10. Push the bottom end into the bottom fitting.
11. Slide metal clip through tiny holes in each end of the bonnet lifter and secure into position. This stops the lifter from popping out.
12. Repeat on Right
13. Give them a good coat of WD-40
14. We recommend apply a thin layer of grease/rust prevention to the strut ends
15. Stand back admire (please refer to pic 2)
PIC 1
[Edited on 25-08-2010 by brebaz]
|
corsaadzy
Member
Registered: 6th Aug 09
Location: St. Austell, Cornwall
User status: Offline
|
pics dont work mate ... i think i fukked mine up thy were a bastard .. gna order some new ones haha
|
corsaadzy
Member
Registered: 6th Aug 09
Location: St. Austell, Cornwall
User status: Offline
|
its not tht easy to push through the little clips as they say
|
brebaz
Member
Registered: 11th Dec 09
Location: newcastle
User status: Offline
|
when i done it i put the screw into the lifter then put the clip in befor i fitted them then just used a spanner to tighten them mate
|
corsaadzy
Member
Registered: 6th Aug 09
Location: St. Austell, Cornwall
User status: Offline
|
yh i can t even get them in .. only one will go in and ive tried everything believe me aha .. o well
|