Hodgy
Member
Registered: 29th Dec 09
Location: Felling, Tyne and Wear
User status: Offline
|
have a problem need to know where these what the wires are for for a x18xe i have read daveylc's
thread about corsa loom to x18xe1:
Corsa Loom -> X18XE1 loom
1 Red/Blue -> Red/Blue (fuel pump relay output)
2 Blue -> Blue (Temp)
3 Thick Black -> Thick Black, ECU Power feed (IGN 12v)
4 Thick Red -> Fuel pump relay feed (12v)
5 Brown/White -> Brown/White(Immo)
6 Brown / Blue -> Brown / Blue (Immo)
7 Blue/Red -> Brown / White (Immo)
8 Green -> Green (Revs)
9 Brown / Yellow -> Brown / Yellow (Diag)
*Note both pin 5 and 7 goes to the brown/white wire on the 1.8 loom!
i have got a picture here to show as there is 2 blue/red wires 1 being thick other being thin
also 3 thick black wires
starting from top :
wires we have:
BROWN/WHITE
BROWN/BLUE
BROWN/YELLOW
BLACK/BROWN
BLACK(2MM)
BLACK(3MM)
BLUE
YELLOW/RED
BLACK/BLUE
BLACK/RED
BROWN/PURPLE
RED/BLUE
BLACK/WHITE
BLACK(2MM)
RED/BLUE
GREEN
BLACK/RED
WHAT ARE THESE WIRES FOR I KNOW SOME BUT GETTING MIXED UP WITH 3 BLACK WIRES AND THICK RED AND BLUE AND THIN RED AND BLUE
MANY THANKS
ALSO WHAT IS THE GREY PLUG IN THE FIRST PICTURE FOR ?????
|
DaveyLC
Member
Registered: 8th Oct 08
Location: Berkshire
User status: Offline
|
No Disrespect Hodgy but can you keep the questions to the forum and top U-2-U'ing me..
If you have a basic understanding of electronics then ALL of the information you need is in my thread.. Sadly I can't give everyone a free of charge step by step walk through.
|
DaveyLC
Member
Registered: 8th Oct 08
Location: Berkshire
User status: Offline
|
Also the grey plug is the power feed to the Injectors and the oil pressure/level sensors.
It really is quite a simple setup.
|
Hodgy
Member
Registered: 29th Dec 09
Location: Felling, Tyne and Wear
User status: Offline
|
thank you 
|
