griffo8606
Member
Registered: 28th Aug 08
Location: manchester
User status: Offline
|
just done the crank seal (front put back together etc and it pissed out has any one had this did the usual taped around shaft etc etc my question is,is there a difference in the gm seal to a reprodution seal, to me the repo feels softer if no difference what could be going wrong?
|
AlexW
Member
Registered: 25th Oct 08
Location: Essex
User status: Offline
|
Its very easy to not put them in right, I done my rear crank seal about 3 times before I got it right 
As long as its a good quality seal, it will be fine, GM ones would only be earling (I Believe anyway).
|
griffo8606
Member
Registered: 28th Aug 08
Location: manchester
User status: Offline
|
what method did you use when refitting the seal?
|
AlexW
Member
Registered: 25th Oct 08
Location: Essex
User status: Offline
|
Depends
Socket if you can find one the right size, or use a square punch then do it 12, 6, 3, 9 or however.
As long as it goes in square and goes in flush, Should be fine.
|
griffo8606
Member
Registered: 28th Aug 08
Location: manchester
User status: Offline
|
cheers pal sounds like how i had it but will get another seal and try again lol
|
