andyc1234
Member
Registered: 7th Nov 06
Location: Lancashire
User status: Offline
|
Any one on here done a hydraulic clutch conversion. Need one for my f23 was going to try use a mk4 master cylinder and try feed it from the brake fluid reservoir
|
gazza808
Member
Registered: 30th Jun 08
Location: Peterborough
User status: Offline
|
I did one got no pics but very similar to what the golf boys do like this....
I used the master cylinder from an astra
|
andyc1234
Member
Registered: 7th Nov 06
Location: Lancashire
User status: Offline
|
Yea already found that pic on google not a lot of room under the corsa dash tho im running eps aswell i dont think theres room. Going to try mounting it facing out i think
|
gazza808
Member
Registered: 30th Jun 08
Location: Peterborough
User status: Offline
|
I wasn't running a dash or eps so had loads of room,
Looked at the corsa c set up? Sure the clutch pedal is a separate assembly to the other two pedals.
Could also mount it vertical behind the scuttle,
|
andyc1234
Member
Registered: 7th Nov 06
Location: Lancashire
User status: Offline
|
Cant do it from above the servo takes up too much space into the bay should be fine so long as it clears the alt it sticks out a fair bit on the saab lump
|
bigron1988
Member
Registered: 29th Aug 09
Location: Southport, Merseyside
User status: Offline
|
Mk4 Astra parts , mate on Facebook has used them as he has a f23 in his Corsa
|
andyc1234
Member
Registered: 7th Nov 06
Location: Lancashire
User status: Offline
|
I know i can do it with the astra parts its just how far its going to stick out. The alt sits proper low down on the saab engine so space might be a bit tight
|
andyc1234
Member
Registered: 7th Nov 06
Location: Lancashire
User status: Offline
|
Fancy asking for a pic of how hes done it ben?
|
bigron1988
Member
Registered: 29th Aug 09
Location: Southport, Merseyside
User status: Offline
|
|
andyc1234
Member
Registered: 7th Nov 06
Location: Lancashire
User status: Offline
|
Spot on that cheers fella
|