beattie17
Member
Registered: 13th Dec 02
Location: perth Drives: 02 ibiza 20v turbo
User status: Offline
|
well i've got an mcr front bumper and want to fit the induction kit thru 1 of the fog light holes. was wondering if thats good or would it let tomuch water in when its raining?
|
luca2020
Member
Registered: 26th May 02
Location: Maidstone, Kent
User status: Offline
|
how would u make the induction kit reach the fog hole?
|
beattie17
Member
Registered: 13th Dec 02
Location: perth Drives: 02 ibiza 20v turbo
User status: Offline
|
bit of samco hosing? i think
|
beattie17
Member
Registered: 13th Dec 02
Location: perth Drives: 02 ibiza 20v turbo
User status: Offline
|
TTT
|
Adam_B
Member
Registered: 13th Dec 00
Location: Lancashire
User status: Offline
|
It would get covered in crap very quickly, Better sticking it ouy of the wing or bonnet me thinks 
|
beattie17
Member
Registered: 13th Dec 02
Location: perth Drives: 02 ibiza 20v turbo
User status: Offline
|
ok. it was just an idea. i supose id have to clean it a good few times a week if i did that. cheers
|
luca2020
Member
Registered: 26th May 02
Location: Maidstone, Kent
User status: Offline
|
just had some info and thats a very bad idea
this bloke i know had the new astra coupe, he had an cold air feed in his front bumper, went througha very deep pudle or stream, sucked up all the water and has now ruined his car
but the thing is is that its not his car, his company gave him about 10k to get a astra 1.6, instead without telling the company or insurance he put his own money into it and got the 2.2 and modded it up, hes now screwed
|
Blazer
Member
Registered: 31st Aug 02
Location: Devon - Drives: frost blue 1.4L 8V
User status: Offline
|
thats quite a good idea, but then its not, because i was thinking there would be a bit to much host between the filter and the thorttle body
|
Makarus
Member
Registered: 25th Jun 02
Location: Nottingham/Derbyshire Boarder.
User status: Offline
|
It would be good to cut an oval shape in your wing, get a pipe running to it at an angle to seal it and run that straight to your induction kit, with a nice bit of work on the wing you could make it look really smart.
|
