Tom J
Organiser: South Wales Premium Member
Registered: 8th Sep 03
Location: Bridgend
User status: Offline
|
Does anyone know where it is and how to get at it? Rather than paying a garage to fit a new one for £200 i would rather clean it
|
Tom J
Organiser: South Wales Premium Member
Registered: 8th Sep 03
Location: Bridgend
User status: Offline
|
ttt
|
Cybermonkey
Member
Registered: 22nd Sep 02
Location: Sydney, Australia
User status: Offline
|
Get yourself a haynes manual, it describes this in explicit detail
|
Tom J
Organiser: South Wales Premium Member
Registered: 8th Sep 03
Location: Bridgend
User status: Offline
|
i got the haynes manual, cant find it in there tho, do you know what page its on coz its not in the index and i have looked through it.
|
Bennn
Member
Registered: 20th May 01
Location: was newcastle now Sweden
User status: Offline
|
if you cant even find it in the haynes manual i wouldnt try removing it yourself!
what engine is it? Mine is located in the inlet manifold - exactly where depends on your engine. Its held on by two torx head bolts, unscrew it, dont lose rubber ring gasket, spray with carb cleaner, WD40 then 3in 1, push the sensor back into the housing and pop it back in. Easy
[Edited on 09-11-2003 by Bennn]
|
and-m
Member
Registered: 5th May 02
Location: Liverpool. Drives. Skud vRS.
User status: Offline
|
engine?
|