5doormodder
Member
Registered: 16th May 02
User status: Offline
|
Right, I just painted my back bumper, all was going well until i applied the laquer, it ran ! arghhhh ! it isnt too bad but its quite noticable.
Is there any way you can rub down the laquer and re-apply it? or do i have to rub it right down and re do the colour coat and the laquer ?
heeeeeeeeeelp !
|
Mav 3000
Member
Registered: 16th Aug 01
Location: Leicestershire
User status: Offline
|
Sand it back to the colour,then colour again then lacquer again.
Also you have to make sure the paint 'keys' to lacquer already on there.
Its a nightmare.
|
broster
Premium Member
Registered: 6th Dec 02
Location: Drives: E39
User status: Offline
|
rub down the area that the run is on not too much just so the run is gone, then polish it alll up
|
5doormodder
Member
Registered: 16th May 02
User status: Offline
|
will that really work broster ? should i use loads of t-cut on it ?
|
1600power
Member
Registered: 22nd Apr 04
Location: Shropshire Drives: 1.6 16v Sport
User status: Offline
|
quote:
Originally posted by 5doormodder
will that really work broster ? should i use loads of t-cut on it ?
tcuts w@nk dont even attempt to use it!!!!
Basicully u will have to sand down to colour and then re-laquer the effected area...makesure u sand with 1200grit (wet) and u shud hopefully remove the run!
no other way than the above im afraid its a bastard i know but u live and learn!
|
