Simon_16v
Member
Registered: 14th Aug 06
Location: Yorkshire
User status: Offline
|
My exhaust is blowing right after the cat where the pipe that joins the cat to the centre section is. Fucking blows just as i managed to get my backbox fitted properly and stop banging over every bump
I've taken the clamp off and tried to move it right to the end and tighten it up as much as i could including using my legs lol and its still blowing.
What would be the easiest way to get it fixed?
Thanks
|
andyc1234
Member
Registered: 7th Nov 06
Location: Lancashire
User status: Offline
|
exhaust sealant
|
Simon_16v
Member
Registered: 14th Aug 06
Location: Yorkshire
User status: Offline
|
Anything else i could do?
Might take it to a place in my break at college tomorrow
|
andyc1234
Member
Registered: 7th Nov 06
Location: Lancashire
User status: Offline
|
jack it up under the clamps and separate the pipes and swear sealant round and push them back in. thats all an exhaust place will do. either that or try sell you a new exhaust
|
Simon_16v
Member
Registered: 14th Aug 06
Location: Yorkshire
User status: Offline
|
Whats the easiest way to seperate them?
Iv always found it to be on pretty tight. Would a hammer with bit of wood be alright?
Also how much is exhaust paste?
|
davec495
Member
Registered: 16th Sep 07
Location: Willington, County Durham
User status: Offline
|
get the paste 4 about 3 quid m8 sorted mine straight away and its still alrite a month later
|
Simon_16v
Member
Registered: 14th Aug 06
Location: Yorkshire
User status: Offline
|
Ah right. Il get some exhaust paste and get it done tomorrow.
Do you have to leave it a set time or can you drive straight after you put it on the exhaust?
|
davec495
Member
Registered: 16th Sep 07
Location: Willington, County Durham
User status: Offline
|
think u gota let it tick over 4 a while or u can drive it as long as ya dont high rev it probs best 2 leave it ticking over says on the box cant remember exactly
|