dan_c4rsa
Member
Registered: 12th Dec 06
Location: North Yorks Drives: MK3 Seat Cupra
User status: Offline
|
my fooking exhaust wont stop blowing even though the sleeves are tightenend up as much as possible. Ive even gummed it and it still likes to blow.
Nice sound from the back though - fooking ashley.
Anyone wonder why? and yes i am using 58mm clamps on it which are the right size.
|
ShEp
Member
Registered: 9th Aug 05
Location: Dingwall, Highland
User status: Offline
|
Sleeved joins defo pushed on enough?
check clamp size, this ring end should be tight to the curve of the exhaust
does it have a drain hole in the BB?
get a mate to stick his hand over the tailpipe and you lie underneath and listen see where its coming from
or it may just take a decent run to seal up properly
|
dan_c4rsa
Member
Registered: 12th Dec 06
Location: North Yorks Drives: MK3 Seat Cupra
User status: Offline
|
the clamps are fine, fits perfectly.
sleeves are all on far enough.
is only blowing from the mid section really.
is just annoying as hell as its a full system and ideally shouldn't blow at all
|
DJBadBoi9901
Member
Registered: 13th Feb 08
Location: South Yorkshire
User status: Offline
|
try turning the clamps 90 degrees it might just be clamping the top and bottom and not the sides
|
dan_c4rsa
Member
Registered: 12th Dec 06
Location: North Yorks Drives: MK3 Seat Cupra
User status: Offline
|
ive done that matey. tried them in all positions.
|
OliSteadman
Member
Registered: 14th Oct 07
Location: Barnsley
User status: Offline
|
when putting the new exhaust on did you use a new mushroom where the down pipe meets the cat pipe?
|