Wayne
Member
Registered: 19th May 04
Location: Haslingden, Lancashire
User status: Offline
|
Fitted my coilovers, used most parts from my old susspension and followed the fitting guide, i strugled to get the nut on the stop of the threaded screw bit, just wondering if this is the order everything shud go as it's a very tight squeeze.
Spring
cup
bearing
spacer
rubber
cup
nut
Is this rite? I compressed the spring quite alot, tightened it as much as i can. Should i be ablt to see any thread in the cup? I'm worried it's not correct.
|
Wayne
Member
Registered: 19th May 04
Location: Haslingden, Lancashire
User status: Offline
|
any1?
|
DaveB
Member
Registered: 29th Dec 00
Location: Huddersfield
User status: Offline
|
Wind the adjuster down to the bottom of the coilover, should easily be able to get to the thread then
|
Wayne
Member
Registered: 19th May 04
Location: Haslingden, Lancashire
User status: Offline
|
yeah i have done, is there something that i shouldn't be using off the old suspension?
|
DAZ1985
Member
Registered: 3rd Sep 06
Location: Scholar Green, Cheshire
User status: Offline
|
Sounds like you've got helper springs on too. Have you pulled the damper all the way up?
|
Wayne
Member
Registered: 19th May 04
Location: Haslingden, Lancashire
User status: Offline
|
yeah i have done, was speaking to beardy before, he rekons i am trying to put to much on. Do i need the aluminium spacer? If not i will get the nut on alot easyier.
Sounds like it shud be
Spring
Spax Collet that aligns the spring sraight
then the bit with the bearing inside
rubber
cup
then bolt it all to gether
|
