adam 1.4 sport
Member
Registered: 2nd Jun 08
Location: luton
User status: Offline
|
Hello people..... Right. When i had a 1.4 sport i was using alot off water eg everyday filling up again.... when i started it from cold it used to like burble and we found out the head gasket went...so i then replaced the 1.4 enigne with a pre eco gsi engine.....now i aint not using hardly any water but now and then when i start the engine from cold. i get this burble.... what could this mean..... And i know my loom has had it in the o2 sensor department..... so it is telling my engine its running which it aint so more fuel is going on...... as its over fueling like fcuk
[Edited on 05-04-2009 by adam 1.4 sport]
|
lil_g
Member
Registered: 29th Oct 06
User status: Offline
|
Is it still using a lot of water?
Is the oil very creamy?
these are usual signs of HG failure.
|
johnhara1
Member
Registered: 19th Oct 06
Location: Newcastle upon Tyne
User status: Offline
|
Just sounds like an Airlock in water system.
Thats all it was on my Corsa.
Burble from behind the dash area yeah?
|
adam 1.4 sport
Member
Registered: 2nd Jun 08
Location: luton
User status: Offline
|
.... i mean the like engine burbels...... sounds like its gunna stall but after a while it is ok...... check oil cap and dipstic and no sings of head gasket yet :S:S ....
|
adam 1.4 sport
Member
Registered: 2nd Jun 08
Location: luton
User status: Offline
|
.... i mean the like engine burbels...... sounds like its gunna stall but after a while it is ok...... check oil cap and dipstic and no sings of head gasket yet :S:S ....
|
Will94
Member
Registered: 1st Nov 02
Location: Nr. Ipswich, Suffolk
User status: Offline
|
Might be worth doing a compression test as a finite way to see if the HG is playing silly buggers
tbh though if its being funny on a cold start it could just as easily be a wanky sensor. you said somethign is wrong with your o2 sensor, that could cause it. they are cheap enough off ebay
|
adam 1.4 sport
Member
Registered: 2nd Jun 08
Location: luton
User status: Offline
|
i hope is it... but its my actually loom that has gone as 1 off my 3 wires for my 02 burned out..... so we had to cur them and soilder them again... but 1 and since then my eml comes on as soon as i start and never goes off...
|
