Partyvan
Banned
Registered: 21st Feb 09
Location: Nottinghamshire
User status: Offline
|
Can I swap my servo to inlet manifold pipe?
The 1.0 12v one has a vacuum fitting, I need one of the ones with a threaded nut on the end. Do they swap over, if so how?
Cheers
|
Terry12
Member
Registered: 24th Sep 07
Location: Manchester
User status: Offline
|
I cut my Corsa pipe down, Used the XE threaded part with some platic pipe and used a 1 way valve to join the 2 together.
I heated up the plastic pipe then pushed it onto the valve. Once cool it should be formed around the ridges on the valve.
|
DaveyLC
Member
Registered: 8th Oct 08
Location: Berkshire
User status: Offline
|
The 1.0 is threaded under that stupid plastic connector, its just a bit of a trick to unscrew it without ripping the connector out.
|
Partyvan
Banned
Registered: 21st Feb 09
Location: Nottinghamshire
User status: Offline
|
Cheers lads I'll try joining them with a one way valve.
|