Rob-e91
Member
Registered: 11th May 09
Location: South Wales
User status: Offline
|
and it seems to have more of a flat spot at low revs! my only thought was is it because the ecu isnt used to the new mods like the dbilas inlet and 4 to 1, would a remap sort this?
|
Piér
Member
Registered: 4th Jan 10
Location: Gloucestershire
User status: Offline
|
Take the battery off for an hour and then re connect and the ECU should adjust accordingly, if not then remap deffo
[Edited on 30-06-2010 by Piér]
|
Rob-e91
Member
Registered: 11th May 09
Location: South Wales
User status: Offline
|
ok cheers
|
Piér
Member
Registered: 4th Jan 10
Location: Gloucestershire
User status: Offline
|
Its just the ECU remembers settings its made for its self and if you dis connect the battery for long enough it will forget, the car might seem lumpy when you first start it but thats just the ECU setting its self back up, take it for a drive once its idling normal and drive how you normally do
|
Rob-e91
Member
Registered: 11th May 09
Location: South Wales
User status: Offline
|
I've been thinking of aftermarket management because its only a few more quid than a remap on ebay
|
Piér
Member
Registered: 4th Jan 10
Location: Gloucestershire
User status: Offline
|
It will probably help if your at stage one with a filter and straight through exhaust as the ECU might not cope but It should be ok!
|
Rob-e91
Member
Registered: 11th May 09
Location: South Wales
User status: Offline
|
It's got a dbilas inlet manifold a 4 to 1 exhaust manifold de-cat, and a k&N pannel filter/cold air feed, would that be a stage 1? I would have thought so. what would stage 2 be, cams and a remap?
[Edited on 30-06-2010 by Rob-e91]
|
Piér
Member
Registered: 4th Jan 10
Location: Gloucestershire
User status: Offline
|
Yeah thats stage one, probably do with a remap and maybe higher revs? but that involves uprated engine parts! Um stage two will be cams and remap and probs uprated engine internals because of the extra power, what engine you got?
|
Rob-e91
Member
Registered: 11th May 09
Location: South Wales
User status: Offline
|
x14 mate, im aiming for cams/verniers arp rod bolts higher rev limiter and a remap next
|
Piér
Member
Registered: 4th Jan 10
Location: Gloucestershire
User status: Offline
|
Why not just 20xe it? Cost about the same? Its gonna cost a bomb to get good power out of a 14xe
|
Rob-e91
Member
Registered: 11th May 09
Location: South Wales
User status: Offline
|
quote: Originally posted by Piér
Why not just 20xe it? Cost about the same? Its gonna cost a bomb to get good power out of a 14xe
Just dont fancy a 20xe, im looking for a c16xe to do in stead of the 1400
|