jons1
Member
Registered: 11th Jun 12
User status: Offline
|
Hi
My cambelt snapped on Friday due to the tensioner being bad and very noisy.
Water pump was not siezed and we have replaced both of these and the belt.
Snapped before I could get into 2nd gear was only doing 12mph.
Put all back together today with new parts and now have no compression on cylinder No. 4
Have checked and there is no broken followers.
Engine type is C12NZ only done 70k miles
Just wondering what else this could be?
Thanks for any help.
[Edited on 30-12-2012 by jons1]
|
Joey 1.6 sport
Member
Registered: 23rd Oct 11
Location: Kent
User status: Offline
|
When mine snapped when I had a 8 valve it bent valves you should off just removed head
|
Martin W
Organiser: South East
Premium Member
Registered: 10th Aug 09
Location: Welling, Greater London
User status: Offline
|
if you've got no compression on cylinder 4 you've got bent valves. should only be the two though.
|
jons1
Member
Registered: 11th Jun 12
User status: Offline
|
Got engine stripped down. Found one bent exhaust valve.
Is there anywhere on the internet that sells these?
|
Martin W
Organiser: South East
Premium Member
Registered: 10th Aug 09
Location: Welling, Greater London
User status: Offline
|
You should be able to get them from
Your local motor factors mate. Don't forget a new stem seal too, would be silly not to replace while its out
|
