Calum1577
Member
Registered: 30th Jan 04
Location: Troon
User status: Offline
|
Just bought a new audiobahn sub and cant figure out the correct way to wire it up. It has 4 terminals on each side of the magnet. 2*+ and 2*- on each side. I have a 2 channel amp which can only be bridged to one channel cannt bridge both channels. Whats the best way to wire up the sub. Ps its a 600w amp. Cheers.
|
langey
Member
Registered: 7th Sep 03
Location: Wigan
User status: Offline
|
i went from the amp to the + on one side, then to the + on the other side, and the same with the -
but let some one back that up before you do it, because i aint 100% sure.
|
Ric_Cav
Member
Registered: 10th Mar 03
Location: Darkest Sheffield
User status: Offline
|
you'll need to find out what Ohms the amp and sub run at, then you can work out which way will be the best while giving the correct Ohm Load on each amp and sub
|
Ric_Cav
Member
Registered: 10th Mar 03
Location: Darkest Sheffield
User status: Offline
|
other than that, just run 2 channels, one +/- to each side
|
Dom
Member
Registered: 13th Sep 03
User status: Offline
|
quote:
Originally posted by Ric_Cav
other than that, just run 2 channels, one +/- to each side
aye could do this, but they you will need to make sure the gains are matched perfectly...otherwise it will sound fooked 
best bet mate, wack the model of your sub up and mode of amp and im sure someone will tell you the best way to wire it up 
|
