Rybo
Member
Registered: 6th Mar 08
Location: Cumbria
User status: Offline
|
could anybody please tell me the width and diameter of vectra v6 discs?....
ive been offered some brembo 4-pots off a audi s2 and have the contact to machine some brackets up
i was hoping to use these discs as i know they're roughly the same size...just wanna know if its a possibility or bin the idea
any advice/help greatly appreciated 
[Edited on 13-03-2008 by rybo8655]
|
jamesvalver
Member
Registered: 21st Feb 03
Location: Bury St Edmunds, Suffolk
User status: Offline
|
288x24mm i think
|
Limecat
Banned
Registered: 25th Jun 05
Location: The Internet
User status: Offline
|
The proper way to do it is to fit the discs and then go about calculating the centre point from the calliper mounting point on the hub.
In a nutshell you will have to measure, measure and measure again as no one will be able to give an accurate measurement for the brackets.
|
Rybo
Member
Registered: 6th Mar 08
Location: Cumbria
User status: Offline
|
so ideally if i get a spare hub on the work bench mount a disc on it then sit the calliper over it central and mock somet up as a test fit? then worry about wheel clearence? the audi discs are 304x28
so do you think its a goer??
|
Rybo
Member
Registered: 6th Mar 08
Location: Cumbria
User status: Offline
|
bump for some help?? : (
|
