gowzzer
Member
Registered: 16th Feb 08
Location: Dundee City
User status: Offline
|
Hi all
Right.. Basically when i put my foot right to the floor the car gets to 3,500-4,000 revs and the ecu light comes on and slows right down and is lumpy to drive but if i raise my foot off the floor the revs go up fine :S
I was thinking the air flow meter but not sure what to do to it where it is etc or if it is even that thats causing the problem.
response a.s.a.p
cheers all
|
DAZ1985
Member
Registered: 3rd Sep 06
Location: Scholar Green, Cheshire
User status: Offline
|
what engine?
|
gowzzer
Member
Registered: 16th Feb 08
Location: Dundee City
User status: Offline
|
1 litre 12 v
|
DAZ1985
Member
Registered: 3rd Sep 06
Location: Scholar Green, Cheshire
User status: Offline
|
sounds like afm
its found in between the air box and the top of the tb
got a plug on it
unplug it see if its any different
|
gowzzer
Member
Registered: 16th Feb 08
Location: Dundee City
User status: Offline
|
how many pins should it have. the one i have pulled out has 2 and when its disconnected the ecu light is on.. is this the one? its plugged into the side of the engine and connected to the pipe on the air box
|
DAZ1985
Member
Registered: 3rd Sep 06
Location: Scholar Green, Cheshire
User status: Offline
|
im not sure about how many wires it was years ago i had an ecoshed
its a bosch unit iirc
chances are its that anyway. same on a x10xe (1.0 12v) as it is on a x12xe (1.2 16v)
|
gowzzer
Member
Registered: 16th Feb 08
Location: Dundee City
User status: Offline
|
ok i will take it for a driv end see.. also someone said if i reset my ecu it could help cos i hav an k&n filter.. what you think
|
DAZ1985
Member
Registered: 3rd Sep 06
Location: Scholar Green, Cheshire
User status: Offline
|
http://www.corsasport.co.uk/board/viewthread.php?tid=262142
|