Will94
Member
Registered: 1st Nov 02
Location: Nr. Ipswich, Suffolk
User status: Offline
|
Picked up my freshly reprofiled camshafts yesterday, when i asked is there any special procedure i should follow or just fit em as per normal
they set i need to "let down" the tappets so they pump up to the correct distances for the new profile and they told me how it is done (allthough difficult without the tool theyve got)
Has any1 ever had any experience with this before? i'd never heard of it tbh lol
|
andyc1234
Member
Registered: 7th Nov 06
Location: Lancashire
User status: Offline
|
no just put them in they will sort them selves out
|
Will94
Member
Registered: 1st Nov 02
Location: Nr. Ipswich, Suffolk
User status: Offline
|
thats what i said to them.... wont the tappets pump up and readjust on their own
they told me that they wouldnt pump up in time and i'd probly fuck the lobes on the shafts
|
andyc1234
Member
Registered: 7th Nov 06
Location: Lancashire
User status: Offline
|
just turn it over with the coil unplugged for a few seconds to make sure they have oil
|
modded_corsa
Member
Registered: 9th May 03
Location: Middlesbrough
User status: Offline
|
when fitting cams at work, i normally drizzle a little bit of fresh oil onto the top of the cam followers/tappets and also drizzle fresh oil where the cam touches cam carriers
never had a problem
[Edited on 26-10-2008 by modded_corsa]
|
gavin18787
Premium Member
Registered: 22nd Feb 05
Location: Basildon, Essex
User status: Offline
|
I think if you look in the tutorials dave did a bit on cams and fitting i think it was covered in there
Drives supercharged Tec with torque
|
Will94
Member
Registered: 1st Nov 02
Location: Nr. Ipswich, Suffolk
User status: Offline
|
i had a look at that thread, doesnt mention the tappets unfortunatly
They gave me some assembly lube to drizzle over the tappets and lobes when i put it back 2getha.
Jus wasnt sure if this is one of those things thas like an old wives tale about needing to let the tappets down.... dont wanna risk buggering the new shafts either
|
gavin18787
Premium Member
Registered: 22nd Feb 05
Location: Basildon, Essex
User status: Offline
|
try a u2u to warren i think his were freshly done when he put his in.
Drives supercharged Tec with torque
|
Will94
Member
Registered: 1st Nov 02
Location: Nr. Ipswich, Suffolk
User status: Offline
|
good idea i'll see if i can get hold of him. cant seem to pull these old tappets apart
like i say i've never heard of it being done before, these guys insisted i need to tho
|